The safety of the grounding circuit to use a specific device or equipment is very important. solar ground screw ground contribute to any surge

or short circuit on the circuit board, where it is to terminate the grounding rods route. The dryer is grounded through the

power cord, because it is connected through an electrical outlet circuit. Make sure the power cord is connected correctly and

/ or a grounding wrist strap to wear your hair dryer.

A dryer power cord to unplug the exports from the 220-volt hair dryer. Slide the dryer away from the wall access panel.

2 Remove the access panel of the dryer framework in the screws. The access panel is located adjacent to power lines,

including power modules, helical anchor power cord is wired. Set screws and the side panels.

3 to find the power supply module in the framework of the green grounding screw on the dryer. If there is no wire or ground

wire connection screw; dryer ground. Ground dryer, center screw loose and remove the power block. Through the end of the

grounding wrist strap hole, and insert the screw in the center hole of the power block. Tighten the screws. Green under the

framework of the dryer for a grounding wrist strap screwed to the other end.

If the wire or ground wire to the green colored grounding screw on the frame of the dryer, the dryer has been grounded.

Proceed to step 4.

4, to replace the rear access panel of the dryer, and insert a screw into each hole. Tighten with a screwdriver.

5 Ground screw drying lines to re-insert the air inlet. Slide the dryer back to its typical operating position, and to test its power.